Can Am Outlander 850 EFI XTP [2016-2018] - Connecting rod rod - Can Am

HOT RODS connecting rod for Can Am Outlander 850 EFI XTP

The HOT RODS connecting rod set is designed for overhauling hot rods and OEM crankshafts. It connects a connecting rod with the associated components for installation in the 4-stroke engine of the Can Am Outlander 850 EFI XTP.

Function and set scope

The set includes a connecting rod, a crank pin, a crank pin bearing and an upper connecting rod bearing. Thrust washers are included if applicable to the application. The pack size is 1 unit.

Technical data

• Engine type: 4-stroke
• Large end, outer diameter: 61,500 mm
• Large End Inner Diameter: 43mm
• Large end, width: 19 mm
• Center-to-center length of connecting rod: 117 mm
• Small end, inner diameter: 20 mm
• Small end, outer diameter: 31 mm
• Small end, width: 19 mm

Vehicle assignment

The connecting rod set is designed for the Can Am Outlander 850 EFI XTP, built between 2016 and 2018. The dimensions given support the comparison with the existing crankshaft and the intended engine components.

Factual note

Before selection, the technical dimensions should be compared with the existing application. The required number of connecting rods per vehicle depends on the respective application instructions.